enjoy this info if you can make it work (i did not)
Here it is:
----- Original Message -----
From: Ted Rey
To: Hans S
Sent: Monday, September 06, 2010 5:44 PM
Subject: Copper Configuration
Hello, we are going to get started on the copper. for this method airflow and AL boat
is not required. You wil need poured copper not pressed. If you purchase pressed
you will need to melt it then repour it. once you repour take your bars and wrap them
tightly in aluminum foil. Wrap with about 30 layers of aluminum foil.
Place the copper in the in the center of the reactor. Set temperature to 291 C, let it resonate for 48 hours.
Then turn the temperature to 303 C let it resonate another 48 hours.
After you 4 days of resonance, remove the copper from the reactor and let It cool.
After cooling we will run thru the next phase which will require electro digestion.
Please test and take pictures of the copper before and after resonance.
Regards,
this is wat you should get according to Joe C :
----- Original Message -----
From: Dr. Champion
To: Dr. Champion
Sent: Friday, December 17, 2010 5:52 PM
Subject: A non expected advancement
This will not be seen on my website and is for the licences holders only
A little background
I took some of the 303 copper and added 90% silver and melted it together. The piece was drilled and sent to the laboratory below. The silver in the piece was put into the mix. What this means is that the Pt and Au came from the copper. Making the percentage of Pt and Au equal to the material from the copper. This means that the entire amount of Au and Pt in the button attached is ~50^ gold and 50% platinum.
I considered it to be Ag and Au due to limited equipment. And it origination from Cu. Below is the original transcripts from the laboratory that did the analysis.
Now I will bet busy on Rare Earths
To fully understand the analzsis below take out the silver for I intestinally added it
Dr. Champion
---------- Forwarded message ----------
From: David S
Date: Thu, Dec 16, 2010 at 5:45 PM
Subject: Fw: Assat results
To: drc@drjoechampion.com, drjoechampion@gmail.com
----- Forwarded Message ----
From: "ray" To: dschutz
Sent: Thu, December 16, 2010 4:21:18 PM
Subject: Assat results
David, the assay results of the sample you sent
in are as follows. Written report will go out in
the mail tonight. Gave you results in percentages
as requisted. Thanks, Ray
Unmarked sample, metel chips,
Au- 3%
Ag- 91% high grade silver
Cu- 1%
Ni- 1.5%
Pt- 3%
Does not total 100%
